icom ip remote control software rs ba1 v2

You also need a USB CI-V interface cable and a WinKeyer (on/off keying does not travel well over the internet). The drawback of this solution is of course that you need to have a PC running at the transceiver location. Two instances of TCP2COM running in parallel. Also add shortcuts to Windows start menu. They both create individual INI files so they can have different settings. COM2TCP2.EXE is a copy of COM2TCP.EXE and TCP2COM2.EXE is a copy of TCP2COM.EXE. Remember also to make a shortcut of them in the Windows’ menu folder so you can start them without digging through folders. This is most easily done by just making a copy of the COM2TCP and TCP2COM binaries in the installation folder. There are free alternatives such as HamachiĬOM2TCP normally does not allow more than one instance but by simply making a copy of the executable file with a different name, you can run as many as you like. If you consider it so, there is always the possibility to tunnel your remote control via VPN. Communications are without encryption and password protection but this is not considered a big limitation. It allows transferring serial communications over a LAN or even the internet. It is a little pricey but this only due to the cost of the embedded Eltima virtual port software license. There are hardware for transferring serial communications (such as CI-V radio control or WinKeyer commands) over a LAN or the internet but this is not a very practical solution.Īstrogeeks COM2TCP is a software that allows doing exactly this. For high quality remote operation you need at least one more COM-port, or preferably two if you use a WinKeyer at the radio. However, running the radio remotely with RS-BA1 occupies the single CI-V radio control interface provided by the ICOM Remote Utility. Also, the remote VFO knob RC-28 is supported for low-latency, manual tuning. Modern ICOM radios have excellent remote control capabilities and with ICOM’s software RS-BA1 Version 2 dual receiver/dual waterfall radios are now fully supported.

Icom ip remote control software rs ba1 v2